| Permanent Raised Bed Gardening: Multiple Tire Board Design |
|
||||
Introduction
Bed Layout
Site Selection
Site Preparation
Plot Layout
Recycled Auto Tire Beds
Rubber Board Fabrication
Multiple Tire Design
Recycled Auto Tire Bed
Plastic Mesh Beds
Material Preparation
Bed Assembly
Corrugated Sheet Metal Beds
Material Preparation
Bed Assembly
Preparing Beds for Planting
Soil Preparation
Seed Bed Preparation
Installing a Drip Irrigation System
Plastic Mulch Application
Planting Techniques
Water Management
Feeding the Growing Garden
Selection and Use of Fertilizer Injectors
Overcoming Weather Woes
Low (Mini) Tunnel Plans
Growing Vertically
Soil Solarization
Appendix
 Sectioning tread with a cutting jig made from three laminated 2- by 12-inch boards. A gap between the top two boards is necessary to provide clearance for the blade. |
|
 Fastening a 6-inch wide piece of rubber to the board to form a pocket. |
 A 30-foot rubber board ready for transport. |
 Removing screw tips with a grinder. |
 Use a grinder to remove wire stubs |
| < Previous: Multiple Tire Board Design (2 of 3) | Next: Recycled Auto Tire Bed Assembly > |
© 1997-2008 by The Samuel Roberts Noble Foundation, Inc.